Low Cost Wall Thickness Gauge - TI-25LT - ELECTROMATIC Equipment Co., Inc.

Low Cost, Ultrasonic Wall Thickness Gauge

TI-25LT
Measuring Range
0.040 - 6.00 inches
1.00 - 150.0 mm

The new CHECK-LINE TI-25LT Wall Thickness Gauge accurately measures wall thickness and the extent-- from only one side!

Standard configuration: In its standard configuration, the TI-25LT is factory set to measure steel only.

Optional configuration: As a "no cost" option, the TI-25LT can be factory set to measure on any other single material instead of steel.

Easy upgrade to full TI-25M functionality (refer to separate data sheet). TI-25M measures on all metals, ceramics, glass and most rigid plastics. It provides Single Reading and Scan modes, where the probe is dragged over a large measuring area. The minimum reading recorded during the "scan" is displayed.

Upgrade to TI-25M requires factory installation of enhanced circuit board, new firmware and keypad.

Resolution of 0.004 inch (0.01 mm)

Large, backlit LCD display retains last reading

Simple operator controls virtually eliminate training

Special-purpose probes are offered for a variety of applications

Switch-selected units for inches or mm

For underwater surveying, probe cable lengths up to 50 feet are optionally available

The TI-25LT probe is waterproof and can be submerged in water

The gauge is impact-resistant and environmentally sealed to provide trouble-free operation under the toughest field conditions

4 Step Steel Test Block

Precision Machined and Finished
Includes NIST Report and Test Data
Wooden Storage Box Optional

Click here for more information

Protective Holder

Constructed from heavy duty Cordura Nylon
Includes Includes wrist & shoulder straps
Built-in belt loop

Range*	0.040-6.00" (1.00-150.0 mm) Other ranges available with optional probes.	Temp. Limits	Ambient: -20 to 120° F (-30 to 50° C) Material: 0 to 200° F (-20 to 100° C) Special high temperature probes are optionally available
Resolution	.004" (0.01mm)	Battery Type	Two AA batteries
Display	4½ - Digit, 0.5" Backlit LCD	Battery Life	200 hours
Velocity Range	.0787-.3937 in/µs (2000-10,000 m/sec)	Weight	710 ounces (280g)
Probe	1/4", 5 MHz, actual wearface is 5/8" (17mm)	Size	2.5 x 4..5 x 1.25" (64 x 114 x 32mm)
Probe Wearface	PEEK (Polyethylethylkytone)	Accessories Included	Probe/cable assembly, 4 oz. bottle of coupling fluid, NIST Calibration Certificate, 2 AA batteries, operating instructions, hard-plastic carrying case.
Cable	4ft. (1.2m) waterproof cable with non-polarized, quick-disconnect connectors. Optional lengths up to 50ft. (15 meters)	Warranty	Gauge: 5 Years Probes: 90 Days

	Minimum radius for convex surfaces	0.5" (12.7 MM)
	Minimum radius for concave surfaces	3" (63.5 mm)
	Probe surface can be rounded to allow it to lie flat in small pipes to 1"
	Minimum headroom	1" (25.0 mm)
	Minimum sample diameter	0.150" (3.8 mm)

Complete Kit includes: Gauge, probe, 4 oz. bottle of coupling fluid, 2 AA batteries, NIST Calibration Certificate and Operating Instruction Manual - all in a foam-fitted carrying case.